No products in the cart.
Related products
- Conveyor Ground Tester
Conveyor Ground Test – LD5900
Conveyor ground test with five steps which informs you whether items to be coated are sufficiently grounded. Designed for electrostatic coating applications.
A poor ground of the pieces to be coated may result in a poor quality of the electrostatic coating work. Coating thickness may not be sufficient or the pieces may not be even covered.
Consult your paint manufacturer or the supplier of your spray equipment for correct values.
The LD5900 is a low cost, easy to use ground check that is battery operated.
SKU: LD5900 - Accessory Products, Climate Testing Accessories, CurveX Tools and Supplies
WIRE-TYPE PROBES FOR CURVEX DATALOGGER CX2063,64,67
Accessory Products, Climate Testing Accessories, CurveX Tools and SuppliesWIRE-TYPE PROBES FOR CURVEX DATALOGGER CX2063,64,67
Wire-type probes to measure either air or surface temperature. Measuring element is an open thermocouple that can be attached by adhesive tape or other mechanical means.
SKU: n/a - Temperature, Temperature and Climatic Testing
Thermometer ST-610B with TC type K input – TE1000
A tough, high-quality thermometer suitable for use with the interchangeable type ‘K’ thermocouple probes.
The practical design, robust casing, large push buttons and the protective holster supplied with the instrument make the TE1000 suitable for use in heavy-duty conditions. The large display panel enables readability at a distance.
Equipped with functions for holding the current value as well as the maximum value.
Range : -50° to +1300°C
Resolution : 0,1°C or 0,1°F
Accuracy : ±(0,5%±1°C), ±(0,5%±2°F)
Dimensions : 165mm x 76mm x 43mmSKU: TE1000 - Adhesion, Adhesion (Wood), ASTM D3359, ISO 2409, ГОСТ 15140
CC3000 Cross Cut Adhesion Test Kit (excluding knife) SP1695
Adhesion, Adhesion (Wood), ASTM D3359, ISO 2409, ГОСТ 15140CC3000 Cross Cut Adhesion Test Kit (excluding knife) SP1695
The TQC Cross Cut Adhesion Test KIT CC3000 is used to test the adhesion of dry coats of paint on their substrate by means of a series of cuts through the coating. Two series of parallel cuts cross angled to each other to obtain a pattern of 25 or 100 similar squares. The ruled area is evaluated by using a table chart after a short treatment with a stiff brush, or adhesive tape for hard substrates.
FULLY ADJUSTABLE
The cutting depth of the TQC Cross Cut Adhesion Test KIT CC3000 can be adjusted while the cutter is guided by two ball bearings to assure reproducible results. The depth of the TQC Cross Cut Adhesion Test KIT CC3000 is adjustable to measure coatings up to 250 µm thick.
SKU: SP1695
