Dark Light
,

CONCRETE INSPECTION HAMMER (MECHANICAL) – LD0500


Instrument for testing the quality of concrete and other construction materials according to UNI EN 12504-2 and ASTM C805. The recoil-force of the automatic hammer is displayed on the scale and indicates the strength of the concrete.

For analysing concretes with a minimum resistance of 10 N/mm2 to values as high as 110 N/mm2, which are now achievable with the ingredients and mixes available today.

$630.00

The concrete test hammer or sclerometer is used for the non-destructive compression strength measurement of concrete. In such a way, concrete is tested for its load-bearing capacity and strength.

The measuring principle is such that the concrete test hammer hits the concrete. Depending on the concrete hardness, the body rebounds, more or less. The rebound is measured by the device and can be converted to a compressive strength.

Since a conventional measurement cannot be carried out in the laboratory when the concrete is built-in, a concrete test hammer is used on site. The measurement is carried out directly on the surface of the concrete and is determined with the help of a conversion table for compressive strength classes. The compressive strength is determined by means of a one-axis, short pressure load without damaging the concrete. The compressive strength of concrete depends on various influence factors such as granules size, water-cement value, fresh concrete density, air content in concrete, resistance to chemical attacks etc.

The strength classes for standard and heavy aggregate concrete refer to the test specimens, which have been stored up to the test age of 28 days either under water or at a relative humidity of 95%. With the sclerometer LD0500, the measured parameters are converted directly in the device and then output.

The LD0500 is a heavy-duty concrete hardness tester or concrete test hammer, also called a concrete rebound hammer or Swiss hammer, used to measure surface hardness and material compression strength. Suitable for use with concrete, rock and building materials, this rugged, manufacturer-calibrated rebound hammer is both easy to use and built to last.

 

LD0500

Concrete Inspection Hammer (mechanical)

Impact energy :2,207 Nm
Measuring range: 10-110 N/mm2
Limitations: Sp.;>100mm
Reference standards: Uni EN 12504 n 2 ASTM C805 BS 1881
Weight: 1,8 Kg

 

Documents

Datasheet
User Manual

Weight 5 lbs
Dimensions 12 × 9 × 6 in
  • Test range: 10 … 60 MPa or 100 … 600 kg/cm² (1450 … 8702 psi)
  • Impact energy: 2.207 J or N-m / 1.6278 ft-lb
  • Impact stroke: 75 ± 0.3 mm / 2.95 ± 0.012 in
  • Radius of spherical tip: 25 ± 1 mm / 0.99 ± 0.04 in
  • kg/cm², psi, and MPa conversion tables
  • Optional test anvil to verify accuracy listed under accessories
  • According to UNI EN 12504-2 and ASTM C805
Scroll to Top