No products in the cart.
Accessory Products, PH / Conductivity Accessories, Storage Solution
Storage solution, 100ml – HI0034
Storage solution, 100ml – HI0034
$25.00
Related products
- Adhesion, Adhesion (Wood), ASTM D3359, ISO 2409, ГОСТ 15140
CC3000 Cross Cut Adhesion Test Kit (excluding knife) SP1695
Adhesion, Adhesion (Wood), ASTM D3359, ISO 2409, ГОСТ 15140CC3000 Cross Cut Adhesion Test Kit (excluding knife) SP1695
The TQC Cross Cut Adhesion Test KIT CC3000 is used to test the adhesion of dry coats of paint on their substrate by means of a series of cuts through the coating. Two series of parallel cuts cross angled to each other to obtain a pattern of 25 or 100 similar squares. The ruled area is evaluated by using a table chart after a short treatment with a stiff brush, or adhesive tape for hard substrates.
FULLY ADJUSTABLE
The cutting depth of the TQC Cross Cut Adhesion Test KIT CC3000 can be adjusted while the cutter is guided by two ball bearings to assure reproducible results. The depth of the TQC Cross Cut Adhesion Test KIT CC3000 is adjustable to measure coatings up to 250 µm thick.
SKU: SP1695 - DFT Dry Film Thickness Gauges, Dry Film Thickness
POSIPEN A – LD6000
PEN TYPE FERROUS THICKNESS GAGE .25-20 MILS
PosiPen has a very small, unique magnet which can be placed with pin-point accuracy on extremely small parts, and on peaks and valleys. Ideal for measuring non-magnetic coatings such as paint, enamel, plating, hot-dip galvanizing on steel.
Used for:
Small, hot or hard-to-reach surfaces
Spot Checks – conveniently fits in a shirt pocket
Hot Sprayed CoatingsIdeal for:
Refineries, petrochemical plants
Platers – electroplating, chrome, zinc, galvanizing
Powder coatersSKU: LD6000 - Accessory Products, Climate Testing Accessories, CurveX Tools and Supplies
WIRE-TYPE PROBES FOR CURVEX DATALOGGER CX2063,64,67
Accessory Products, Climate Testing Accessories, CurveX Tools and SuppliesWIRE-TYPE PROBES FOR CURVEX DATALOGGER CX2063,64,67
Wire-type probes to measure either air or surface temperature. Measuring element is an open thermocouple that can be attached by adhesive tape or other mechanical means.
SKU: n/a - Accessory Products, Adhesion, ASTM D4541, Pull Off
Dolly Drill For Adhesion Test – LD9250
The TQC Dolly Drill is the perfect tool to remove the excess of glue and cut through the coating around dollies in order to prepare the dolly for the adhesion test. Fixed positioning is assured with the three strong magnets, allowing the drill to remove the coating around the dolly without putting any force on the dolly. Manually removing the access of glue and cutting through the coating is a hard job for inspectors that have to do many tests a day, which results in wrist and arm pains. The TQC Dolly Drill eases their work considerably, and increases the accuracy of the pull off adhesion tests because of a perfect vertical cutting movement down to the metal.
For the best reproducible results use the Adhesion tester AT, with the hydraulics and auto positioning feature of the pull-off head.
SKU: LD9250
