Guide and Reference Photographs for Steel Surfaces Prepared by Wet Abrasive Blast Cleaning
Pictorial Standard shows two uncoated, rusted steel surfaces (Conditions C and D) before and after wet abrasive blast cleaning. Photographs illustrate two degrees of cleaning (WAB 6 and WAB 10) for each initial condition, with additional photos that depict the appearance of light, moderate, and heavy flash rust after cleaning. Also contains a written guide to the use of reference photographs and additional explanatory notes. Cleanliness requirements for conditions depicted are defined by the joint SSPC/NACE surface preparation specifications for commercial (SP 6/NACE 3) and near-white blast cleaning (SP 10/NACE 2). Photos of commercial and near-white surfaces achieved by dry abrasive blast cleaning can be found in SSPC-VIS 1.
$195.00
SSPC-VIS 5|NACE VIS 9 Wet abrasive Blast Cleaning
| Weight | 1 lbs |
|---|---|
| Dimensions | 10 × 11 × 1 in |
Guide and Reference Photographs for Steel Surfaces Prepared by Hand and Power Tool Cleaning
Contains a series of 43 full-color reference photographs to be used as a supplement to the SSPC standards for hand and power tool cleaned steel. Shows a total of seven different steel surfaces (four uncoated and three previously coated) before and after hand tool cleaning (SP 2), power tool cleaning with power wire brushes and sanding discs (SP 3), power tool cleaning to bare metal (SP 11), and commercial grade power tool cleaning (SP 15). Also contains photos of SP 11 surfaces with a restored profile, a revised guide to the use of reference photographs, a new table of standards and conditions depicted, and additional explanatory notes.
Guide and Reference Photographs for Steel Surfaces Prepared by Waterjetting
Shows a total of six different steel surfaces (two uncoated and four previously coated) before and after waterjetting. Photographs illustrate four separate degrees of cleaning (WJ 1, WJ 2, WJ 3, and WJ 4) for each initial condition, with additional photos that depict the appearance light, moderate, and heavy flash rust after cleaning. Also contains a written guide to the use of reference photographs and additional explanatory notes. Cleanliness requirements for conditions depicted are defined by the joint SSPC/NACE surface preparation specification for high- and ultrahigh-pressure water jetting (SP 12/NACE 5).
The ACT Orange Peel Standards consist of ten 4×6 inch panels with graduated degrees of orange peel (flow) from rough to smooth. Each panel within the set is painted black and labeled with a corresponding flow rating (orange peel) from 1 to 10.
Great Lakes Gages, LLC
3689 Hadley Rd.
Metamora, MI 48455
